1．Configuring interface Ethernet0: 1) 是否使用此接口： Is this interface in use? [yes]: 2) 是否设置此接口的IP参数： Configure IP on this interface? [yes]: 3) 设置接口的IP地址： IP address for this interface: 192.168.162.2 4) 设置接口的IP子网掩码： Number of bits in subnet field [0]: Class C network is 192.168.162.0, 0 subnet bits; mask is /24 在设置完所有接口的参数后，系统会把整个设置对话过程的结果显示出来： The following configuration command script was created: hostname Router enable secret 5 $W5Oh$p6J7tIgRMBOIKVXVG53Uh1 enable password pass …………
设置HDLC封装 encapsulation hdlc 设置DCE端线路速度 clockrate speed 复位一个硬件接口 clear interface serial unit 显示接口状态 show interfaces serial [unit] 1 注:1.以下给出一个显示Cisco同步串口状态的例子. Router#show interface serial 0 Serial 0 is up, line protocol is up Hardware is MCI Serial Internet address is 150.136.190.203, subnet mask is 255.255.255.0 MTU 1500 bytes, BW 1544 Kbit, DLY 20000 usec, rely 255/255, load 1/255 Encapsulation HDLC, loopback not set, keepalive set (10 sec) Last input 0:00:07, output 0:00:00, output hang never Output queue 0/40, 0 drops; input queue 0/75, 0 drops
精品推荐