|
| |
 精品推荐 |
 |
|
| |
|
|
|
|
题库精选：CCNA考试自测题第4卷
|
日期：2008年3月5日 作者： 查看:[大字体
中字体 小字体]
|
B. That a single segment can be associated with a range of network numbers
C. That a single network number can be assigned multiple zones
D. B and C only
E. All of the above
31) Which is a true statement about a cable range (关于电缆范围哪个叙述是正确的)？
A. It is a range of addresses assigned to a device
B. It is associated with a network segment
C. It is associated with an interface on the router
D. All of the above
E. B and C only
32) All AppleTalk network numbers must be (所有的A p p l e Ta l k网络号必须是)：
A. Greater than 65 536
B. Greater than 255
C. Less than 65 536
D. Less than 255
33) What is the broadcast node number in AppleTalk (AppleTa l k中的广播节点号是什么)？
A. 255
B. 0
C. 256
D. None of the above
34) For a cable range of 450~454, what is the maximum number of hosts (对于电缆范围为
4 5 0 ~ 4 5 4的情况，最多能接多少台主机)？
A. 762
B. 2286
C. 1016
D. 1270
35) Which of the following is not true of cable ranges (关于电缆范围下面哪一条不正确)？
A. They are assigned with the APPLETALK CABLE-RANGE command
B. They are ranges of network numbers assigned to a segment
C. They cannot overlap with a previously assigned cable range
D. None of the above
36) A network segment X is given a cable range of 200～300. What is the acceptable value
of cable range for segment Y (一个网段X分配给电缆范围2 0 0 ~ 3 0 0，对于网段Y而言，哪一段电
缆范围是可行的)？
A. 250～350
B. 6301～6400
C. 300～400
D. All of the above
37) A segment has a cable range of 700~750. When a node wants to get an address, it may
pick up any network number in the range that is not currently in use (一段分配了电缆范围
7 0 0 ~ 7 5 0。当一个节点希望得到一个地址时，它必须选用当前不在使用的网络号)。
A. True
B. False
38) Which command would be most appropriate for finding out whether the network has
verified a cable range assignment for E0? (哪一条命令对找出网络是否已验证为E 0分配了电缆
范围最为恰当？)
A. SHOW APPLETALK ADDRESS
B. SHOW APPLETALK ROUTE
C. Show appletalk interface
D. Show appletalk zone
39) What cable range is used to indicate to IOS to use AppleTalk discovery mode on a given
interface (把一个给定的接口设置为A p p l e Ta l k发现模式，应使用哪一段电缆范围)？
A. 1~1
B. 0~0
C. 255~255
D. 254~254
40) For AppleTalk discovery to work properly (为使A p p l e Ta l k发现正确工作) :
A. A router must have cable range assigned to it
B. The seed routers must be in place
C. The seed routers must be non-operational
D. All of the above
41) For a basic AppleTalk configuration, how many commands are necessary (对于一个基本
的A p p l e Ta l k配置，多少条命令是必须的)？
A. One
B. Two
C. Three
上一篇:自学通过CCNA考试完全指南(实用版)
下一篇:【CCNA】TestKing 640-801 v40.0
|
| 题库精选：CCNA考试自测题第4卷 相关文章： |
|
|
|
| 题库精选：CCNA考试自测题第4卷 相关软件： |
|
|
|
|
